China Orb, online Chinese to English dictionary with nearly 1 million entries and plenty of excellent examples. The pin yin and pronunciation sound of Chinese wrods are provided. China Orb includes a lot of Chinese professional terms in many industries such as Medicine, Chemistry, Mechanism, Electricity, Computer, Economy, Law, Architecture. If you can not find satisfying translation elsewhere,try China Orb Chinese to English dictionary.

China Orb, online English to Chinese dictionary with more than 1 million entries and plenty of excellent examples. China Orb includes a lot of English professional terms in many industries such as Medicine, Chemistry, Mechanism, Electricity, Computer, Economy, Law, Architecture. If you can not find satisfying translation elsewhere,try China Orb English to Chinese dictionary.

adjusting knob
English: adjusting knob
Chinese: 调整旋钮
调节钮
Examples:
1. Always depressurize a regulator before closing the adjusting knob and removing the regulator from the cylinder.
在关闭调整钮和从钢瓶上断开调整器之前,总是使调整器减压。
2. Check diaphragm regulators for creep (leakage of gas from the high-pressure to the low-pressure side when the adjusting knob is turned fully counterclockwise).
检查隔膜调整器是否有漂移(如果调整钮逆时针方向旋死的话,会出现从高压端到低压端的气体泄漏)。
3. Close the regulator. After relieving all the gas pressure, turn the adjusting knob counter clockwise as far as it will go.
关闭调整器。在释放了所有的气体压力之后,逆时针旋死控制钮。
4. Close the regulator. To close the regulator, turn the adjusting knob to the full counter-clockwise position. The regulator must be closed before opening the cylinder valve.
关闭调整器。要关闭调整器,把调整钮逆时针旋死。在开启钢瓶阀门之前,必须关闭调整器。
5. High-pressure media enter the regulator through the inlet into the high-pressure chamber.When the adjusting knob is turned clockwise, it compresses the range spring and exerts a force on the diaphragm, which pushes the valve stem open.
高压介质通过入口进入高压腔。当调节钮顺时针方向旋转时,它压缩距离弹簧,从而对隔膜施加了一个力,推开了阀杆。
6. Manual adjusting knob
手调旋钮
7. Never exchange the discharge (low-pressure) gauge for one of lower pressure. The gauge may rupture if the adjusting knob is unintentionally turned too far.
禁止把排出量表换成更低压力的量表。如果无意中把调整钮旋的太远的话,量表会破裂。
8. Turn the adjusting knob clockwise and establish the required use pressure by referring to the low-pressure gauge. Make sure that the cylinder valve is easily accessible.
顺时针旋转调整钮,通过查看低压量表建立要求的使用压力。确认钢瓶阀门容易接近。
9. Vent the gas. Vent the gas in the regulator and/or system, or isolate the system, and vent the gas in the regulator by turning the adjusting knob clockwise so that no pressure is trapped inside the regulator.
排出气体。排出调整器和/或系统内的气体,或者把系统隔离开再通过顺时针旋转调整钮排出调整器内的气体,这样调整器内就没有截留的压力。
10. With the regulator adjusting knob turned fully counterclockwise, place both hands on the cylinder valve and open it slowly, allowing the pressure to rise gradually in the regulator.
调整器的调节钮逆时针旋死后,两只手放在钢瓶阀门上,慢慢地开启,使调整器内的压力逐渐增加。